Locking pin hinge replacement for Evo II. Genuine Autel Robotics part. Stocked and shipped from USA.
Note:
- Does not fit Evo I
- When viewed from back of drone, with front camera facing away
- This part has a “1” or “1A” stamped on it
Installation note: In order to properly install, you’ll need to torque the hinge to a “neutral position”. This is done by rotating until the assembly is just about to “flop” to the next angle and letting it rest on the “peak” of that motion. This will allow the hinge to be removed or reinstalled with the arm in a neutral unloaded position. After pushed down into arm and screwed into place, the arm should flop to it’s normal open or closed position and stay that way.
Note: If the arm doesn’t close or open right, most likely the hinge is right, but the assembly is wrong. Remove and recheck!
Reviews
There are no reviews yet.